Formwork — Quantities and Scope
Beam quantity output verified. Other category and linked-model combinations are settings demonstrations.

Select the host and open Formwork
Select a native structural beam. Open BimSpeed dot S T R and choose Formwork. The practice beam is a D three hundred by six hundred millimeter member. The tool can also inspect the active view or a selection; confirm the scope before a larger project run.

Set surfaces and element scope
In From Work, choose Active View for the visible model or Select Elements for a bounded selection. Enable the Bottom, Top and Side surfaces required by your takeoff. Review the eight component category switches. In this installed build the Select Elements checkbox is bound to linked selection internally, so verify the selected set before relying on it for a whole project.

Map custom parameters
Use Add Parameter to map outputs to the project parameters required by a schedule. Confirm that the chosen parameter exists and has a compatible area unit before running. The resource file for the installed add-in was restored from its own supplied fifty three parameter list for this capture.

Run and verify quantities
The selected beam now has F W area eleven point zero two six square meters: bottom two point two zero five and sides eight point eight two one. Those values sum to the total. Verify the parameters in Revit Properties and save the R V T. This is measured output for the native beam case; wall merging and linked elements were not independently proved.