Column Rebar v2.0 — Main Cases
Installed v2.0 settings captured; no clean v2.0 generation result is claimed.

Select the installed v2.0 command
On BimSpeed dot S T R, expand Column Rebar and choose Column Rebar v2.0. The backend rank names ColumnRebarCmd, which is distinct from the classic column rebar tool covered earlier. Work on a copy before creating bars, because an existing cage may be duplicated.

Set geometry and longitudinal bars
Geometry and Rebar sets cover, main bar diameter, edge counts C x and C y, stirrup diameter, hook bar, and section arrangement. Check the preview and the actual concrete section before applying. The captured example shows D eighteen main bars and D eight stirrups.

Set stirrup zones and distribution
Choose uniform or zoned spacing such as A one A two A one. Enter first stirrup distance, close-zone spacing or quantity, and L one criteria. Review lap and top zones and whether stirrups extend into the beam or slab above. Additional ties have their own diameter, hooks and spacing behavior.

Foundation starter bars
The Foundation tab enables waiting or starter bars, split direction, tie spacing, H m and L b. Check the foundation host and the arrow orientation; Reverse changes direction. In this recorded model the tab is a setting demonstration only; no starter bar creation is verified.

General anchorage and run boundary
General includes hook choices, lap and anchorage lengths, partition and elevation data, splice position and beam or floor association. The earlier copied model already contains a classic cage, so these v2 settings were not executed over it. A clean-model output check remains required before using it as a completed v2 reinforcement example.